XTherm Condensing Boilers, 1005A-2005A

The proven XTherm - vertical modulating condensing boiler, in sizes from 1005 to 2000 MBTU. XTherm combines time-honored high-recovery copper fin technology with cutting-edge control and combustion advancements. The installer can enjoy broad installation flexibility, easy commissioning, and long-term reliability.

Features:

• 96% efficiency at full fire.  Condensing. Cat IV venting required.
• Cast-iron headers and pumps with copper finned-tube primary heat exchanger.  Brass headers and cupro-nickel tubes available as options. CSA Low Lead Certified 0.25% Lead
• Minimum continuous inlet water temperature (50°F).
• Electronic modulating gas valve and burner, 7:1 turndown.
• Small footprint, less than 11 square feet.
• On-board diagnostic center, real English, no codes.
• All models indoor/outdoor construction.
• Complete cabinet protects all controls and wiring.
• Certified under SCAQMD rule 1146.2.  Meets all Low NOx regulations.
• Suitable for altitudes up to 10,000 ft. (derate above 5,000 ft.).
• Primary-secondary piping required.
• 0-10 VDC Remote set-point BMS Interface.
• 0-10 VDC Direct Drive.
• Available for natural gas or propane.
• VERSA IC® control package with built-in outdoor reset function.
• Cascade control of up to 8 units, no external sequencer required.
• Cascade in parallel or sequential modulation modes.
• Modbus® RTU port (RS485).
• Touch Screen

Options:

• Outdoor air Sensor (B-32)
• Indirect DHW sensor
• BACNet IP, BACnet MS/TP, Modbus TCP, N2 Metasys (B-85)
• Lonworks (B-86)
• Alarm with 4” Bell (E-5)
• Low Water Cutoff (F-10)
• PVC vent factory installed only (D-32)
• Centrotherm® Polypropylene Vent Adapter (D-33)
• Condensate Neutralizer (Z-12)