model LPDV_Variable-speed line pump Pump with Inverter-Integrated PM Motor

■Usage ①Cold/hot water circulation ②For various machinery sets ③General water supply ■Features ①Compact and lightweight in-line type allows mounting in the middle of piping, eliminating installation space ②It is possible to disassemble and inspect the bomb with the piping as is. ③The external dimensions of IE3 efficient induction motor (JIS C 4213) are the same as those of the permanent magnet motor (PM motor) and the inverter (built-in), providing low initial cost, energy saving, and space saving. [Energy Saving] ・Use a PM motor with 3000/3600min-1 (2 rateds) that is highly efficient equivalent to IE5. Standard: IEC TS 60034-30-2 (variable speed motor) ・Built-in inverter enables easy adjustment to the rotation speed suitable for the site. Large energy savings are achieved by reducing the performance margin that is inevitable for pump selection. [Space-saving, low initial cost] ・No inverter board installation cost required ・No space required for peripheral equipment (with built-in DC reactor and noise filter, in addition to inverters) [Labor saving] In addition to manual setting, control of discharge pressure, estimated end pressure, flow rate, temperature, etc. is possible. [Compatibility] ・External dimensions equivalent to induction motor ・Easy replacement with the same arrangement and face-to-face dimensions and equivalent performance as existing pumps. [Operability] The following operations can be performed by communication using a dedicated application. ・Operation ON/OFF ・Frequency (rotation speed) setting ・Acceleration time, start frequency setting, etc. (Parameters are already set for each model, and complicated initial setting is not required.)

Özellikler

■Standard Specifications
[Handling liquid]
Fresh water 0 to 100°C
[Suction total head]
ー6m (20 °C) *Selection chart Within discharge volume
(Diameter 80 is 50Hz:-5.5m. 60Hz:-3.5m)
[Structure]
Impeller: closed
Shaft seal: Mechanical seal
Bearing : Sealed ball bearings
[Flange]
Suction end :JIS10K (standard)
Discharge end :JIS10K (standard)
[Material]
Casing: FC200
Impeller :SUS304 following models
・Caliber 32, 40
・Diameter 50:0.75kW or more (50Hz), 1.5kW or more (60Hz)
・Diameter 65:3.7kW or more (50Hz), 5.5kW or more (60Hz)
: SCS13 Models other than the above
Spindle: SUS304 (wetted part)
[Inverter]
Power source used: Three-phase 200V (50Hz), 200/220V (60Hz)
Operation method: Constant speed operation.
Various automatic operation control and external analog G signal command operation
Automatic operation control function: Pressure constant, Flow constant, Temperature constant, Differential pressure constant, Estimated end pressure constant
Communication: RS485(Bluetooth Ver.5)
Consultation function: Overcurrent, step-out, low current, output phase loss, overvoltage, undervoltage, electronic thermal (overload), overheat
[Motor]
Out: 0.75～7.5kW
Insulation Thermal Class : 155 (F)
Voltage:200/220V (Primary power supply side)
Rated same wavenumber: 120Hz
Rated speed :3000/3600 min-1
Applicable standards :JEC-2100-2008
Applicable effi ciency: IE5 equivalent
Bearing : Sealed ball bearings
Voltage:200V(0.2～37kW, 45kW)
:200/400V(45～55kW)
Model/protection: Totally-enclosed fan-cooled IP44 (indoors)
Efficiency: IE3(0.75kW or higher)
: Less than IE1(0.4kW)
[Installation location]
Indoors and outdoors