model FS_2Poles_Single-stage end suction pump

■Usage ①General water supply ②Cold/hot water circulation ③Industrial water ④Irrigation ■Features ①We have developed a series of 2-pole type products in pursuit of small size and light weight. ②Bomb efficiency has been drastically improved by adopting an impeller and casing that utilize our original analysis technology. ③The standard specifications (water volume range, liquid temperature, and maximum operating pressure) are wider than those of conventional models, and high indentation specifications (special specifications) are also available. ④A back-pull-out (B.P.O.) structure that enables disassemble and inspection without removing suction, discharge pipes, heat insulation, and cold insulation. ⑤Since the discharge loss is located above the center of the casing and the casing has legs, the structure is resistant to piping loads. ⑥Sealed type coupling guards and protectors are attached to the exposed parts of the rotating body to enhance safety.

Opis

■Standard Specifications
[Number of contacts]
2 poles
[Handling liquid]
Fresh water 0 to 100°C
[Suction total head]
ー6m (20 °C) *Selection chart Within discharge volume
※The aperture 100X80 is-5m
[Max. working pressure]
0.98MPa
[Structure]
Impeller: closed
Shaft seal: Mechanical seal
Bearing : Sealed ball bearings
[Flange]
JIS10K (standard)
[Material]
Casing: FC200
Impeller :SUS304(32X32FS2F, 2G, 40X32FS2G, 50X40FS2G, 2H, 65X50FS2G, 2H, 2J)
: SCS13 Models other than the above
Spindle: SUS304 (wetted part)
[Motor]
Phase and number of poles: 3-phase and 2-pole
Voltage:200V(37kW or less)
:200/400:45kW
Model/Protective type : Totally enclosed fan type/IP44 (indoor)
Efficiency: IE3 (Playmium Efficiency)
[Installation location]
Indoors