ModSec Securus S1

Perimeter security fencing panel system

CLD ModSec is an innovative installation system that can be installed at ground level or as a trench system. It features an in-built channel for wires or services enabling easy installation of CCTV, PIDS, or other electronic devices. Modsec S1 incorporated CLD Securus S1 fence panels. Tested by the Loss Prevention Certification Board (LPCB), Securus S1 offers a minimum delay against attack of 60 seconds.

Features:

Specialist high-security system to withhold a minimum 3 minutes 60 second delay
Recycled materials
Suitable for flat ground or gradients
Built-in services channel
Rental or purchase options are available

사양

Standard: LPS 1175 A1 (SR1) Issue 8, BS1722-14: 2017, BS EN ISO 1461:2009, BS EN 13438:2013
Product Reference: CLD ModSec Securus S1 358 Rigid Mesh Panel System
Description: Mesh and wire panel installed using ModSec concrete base (see separate ModSec Base Q40)
Panel width: 2520mm
Wire diameter: 4mm
Mesh size: 76.2 x 12.5 mm mesh
Available Heights
Select as required: 1830mm to 5000mm
Nominal height: 1.8m to 5m
Finish: Polyester powder-coated to minimum 80 microns.
Any RAL colour
Top edge projection: nil
Panel installation: Maximum 50mm above top of ModSec Base block
Security topping
options: Barbed and razor wire, cranked and straight
Posts: Special flanged post, galvanised after manufacture and polyester powder-coated to match fencing
Post dimensions: 80mm x 60mm. Corner posts: 80mm x 80mm.
Maximum post
Centres: 2520mm +/- 9mm
Fixings: 120mm x 6mm full length clamp bar. M8 Stainless Steel cup square bolt (min 30mm)
Foundations: Install using ModSec foundation system. Must be installed on suitable flat ground, ensuring blocks interlock and posts are installed in every fourth block. Set post into block with suitable compound depending on permanent or temporary installation.
Warranty: Minimum of 15 years against manufacturing defects.
Notes: All dimensions are nominal, for further information please contact CLD Fencing Systems.
Information is correct at time of production. As part of our policy of continuous improvement, we reserve the right to alter product specification without notice.